U0730 BMW Fault Code

Description:

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

U0730 Code Symptoms :

If your U0730 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U0730 and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.

Diagnosis And Repairing U0730

U0730 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to fix U0730 code ?

• EVAP system hose leaking
• EVAP system hose leaking
• Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
• Oil flow restriction in the oil passages or the variable camshaft timing (VCT) valve body

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U0730, so consult the manual to locate the brake fluid reservoir.

Bear in mind that a low fluid level can set code U0730 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.